Blog

Leaking Water Heater, What’s the Deal?

Unfortunately for most of our customers, when they need a plumber they need a plumber stat! A toilet might be overflowing, drains clogged and causing a mess, or a leaking water heater. All of these are problems you want to act on quick, and are worth knowing their potential causes. The sooner you recognize the problem, the sooner it can be fixed, the less damage and cost falls to you!

To that end, this time on the Economy Plumbing Services blog, we are looking at what to do in the case of a leaking water heater, how to diagnose the source of the leak and more in this double sized entry!

Handling a Leaking Water Heater

WARNING: Believe it or not, water heaters get water HOT! Most heaters at factory settings heat water to around 125 degrees. That’s hot enough to cause first degree burns, some heaters run hotter and even indirect contact can burn. Be safe here!

Step One – Find the Source

There are a few possible reasons for water to be spotted pooling under a water heater. It could be a leak, yes, or it could just be condensation from pipes, nearby appliances, and the like. If you have a basement or the weather is particularly damp this might be the cause.

It could also be from water softener or furnace drain lines, or other sections of your plumbing could be leaking instead of the water heater. Here’s how to find the source!

  1. Dry the area completely and then inspect the plumbing and water heater fittings. Wherever the pipes and appliances join, look for water beading.
  2. If no water is spotted, look at possible nearby sources. Look above to where it may drip from. If there is still no obvious source, lay down some towels and check every so often for any additional leaks.
  3. If they don’t appear – hey! There’s nothing to be worried about!
  4. If water does reappear, and there isn’t any other obvious source, it very well could be the water heater.

Step Two – Turn Off the Power

Now that you know the water heater is the likely culprit, you need to turn the power OFF!

Electricity and water are a rough mix. If you have an electric water heater go to your circuit breaker box and look for the breaker for your water heater (if these aren’t labelled, make a note and take care of those when this is settled!)

Is your water heater running off natural gas? Look for a dial or switch on the tank itself, often near the bottom. Be sure it is set to OFF.

Step Three – Turn Off the Water

Most water heaters have a valve right at the top that supplies the cold water to the tank. Turn that off. Sometimes it’s necessary to shut off the water to the house but if you are still unsure of the leak location that can make it hard to diagnose.

Step Four – Where’s the Leak?!

Looking over your water heater with a closer eye for detail can help you identify the problem before calling in a professional, ensuring that they know as much as they can going into it.

Common Places for Leaks

-Cold Water Inlet/Hot Water Outlet

The water inlet/outlet connections take the cold water to the tank to get heated before it is sent out to the feature needing hot water. These should be on the top of the water heater and if the leak is coming from these connections it might be as simple a fix as getting a pipe wrench and tightening a few connections. Not too bad!

-Drain Valve

At the bottom of the tank is something called the drain valve, bet you can guess what this one does! Check to see if the valve is closed completely. Check where the valve connects, there shouldn’t be any moisture. If the drain valve has a leak it can be fixed, it isn’t too serious.

-Temp/Pressure Relief Valve

Also located on the top (or side) of the tank is the temperature and pressure release valve and pipe. This safety device helps ensure that the water in the tank doesn’t get too hot and that the pressure being built up inside is not to the point of bursting. This lets water out of the tank, relieving pressure and bringing the temp down.  If the valve is closed and water is still flowing through the pipe then the valve is defective and in need of replacing. If the valve is open and the water coming then it’s a good bet the leak is fixable. Call a professional!

-Internal Tank

Now, here’s where it gets tricky. The internal tank of a hot water heater is completely enclosed in insulation and the outer shell. A leak inside the internal tank won’t be visible from the outside and the water will leak through the bottom. It is not an uncommon thing for the internal tank to start leaking. With age comes use, with use comes deterioration – when comes to fixing the internal tank the only real fix is to replace the entire unit.

Repair Yourself or Hire a Professional?

Now, with this information you have the know how to figure out where and what the malfunction might be. For some of these the fixes might well be within your own capabilities! Like we said with the inlet and outlets, simply tightening the fittings might be all that’s needed to settle the problem. For others, like the internal tank, replacing the whole unit is the only option or a fix. Be honest with your own abilities and ask “Is this something I can handle or will it just end up costing more?”

Ready to call in the professionals? Give Economy Plumbing Services a call for prompt, dependable plumbing service. Our professionals can have your problem sorted out before you know it, whether it’s repairing or replacing a leaky water heater, repiping a home or anything else you may need.

REMEMBER, IF WATER GOES THROUGH IT OR TO IT – WE DO IT! CALL 520 -214-2149!

Recommended Posts

Tankless or Traditional: What’s the Best Water Heater Option for Your Home?

The decision between tankless and traditional models for replacement water heaters in Tucson can make a real difference in your daily comfort and long-term costs. Let's take a closer look at how each type works, which will help you pick the right fit for your household. Traditional Heaters more Traditional tank-style water heaters store a set amount of water, usually 40 to 80 gallons, in an insulated tank and keep it hot constantly using either gas or electricity. When you turn on the faucet, hot water flows from the tank while cold water refills it at the bottom. Tankless Heaters These heaters only give you hot water when you need it. Cold water passes through a heat exchanger inside the compact unit, and out comes hot water, nearly instantly. Pros of Both Let's consider the pros of the traditional heaters first: They're cheaper up front Installation is simpler because most homes already have the connections in place When it needs replacing, it's simple and often same-day They can handle a high flow rate (lots of usage simultaneously) The pros list for the tankless heater is also enticing: Less wasted energy from water being heated when it's not needed No running out of water, no matter how many people take showers Longer tank lifespan Takes up less space Cons of Both Here's the downsides to be aware of with traditional heaters: They use more energy (much more, in some cases) They run out of hot water, and you have to wait while they refill They're bulky and need more room for placement They need to be replaced sooner than tankless As for tankless heaters, be aware that: Installation costs are usually higher Initial purchase price is higher Flow rate is lower unless you invest in a bigger (or multiple) units Scale can form inside the heat exchanger faster than in a tank model Best Water Heaters in Tucson: Local Factors There are a few local factors that might also influence your decision. We have hard water, so that means scaling is more of an issue. Both types of heaters need to be flushed to prevent buildup, but the tankless might need it more often. We've also already got high energy bills with the hot summers we have here, so trimming that with a tankless model can make a big difference over time. Tankless water heaters pay for themselves in energy savings in about seven years, and if you take care of your model, it can last up to 20.If you're still weighing the options for your specific setup, give us a call at Economy Plumbing Service LLC here in Tucson at 520-885-3510. We're a family-owned business with more than seventeen years of honest, no-pressure service here in Tucson. We'll walk through your usage, space, and water conditions to help you choose the heater that actually fits your home and lifestyle. We also serve clients in Vail, Rita Ranch, Oro Valley, Green Valley, and surrounding areas.

Gas line repair and inspection in Pima County, AZ.

Are Your Gas Lines in Safe? Warning Signs You Can’t Ignore

We rely on our gas lines in Tucson to heat our homes, give us instant hot water, power our stoves, and more. Keeping your gas line safe is a serious responsibility, because the dangers of a problem in the gas line can be deadly. Here's some warning signs to look out for. Warning Signs That Gas Lines in Tucson Are in Trouble Emergency Signs more Some warning signs are emergencies, and you cannot ignore them. Call your gas provider or emergency services and leave the area immediately if: You smell a sulfurous odor in or immediately around your house People in the house are suddenly and inexplicably experiencing headaches, dizziness, nausea, or shortness of breath If gas is escaping into the house, it can cause you and your family serious physical harm. The gas, as you breathe it, begins to displace the oxygen in your blood. You gradually asphyxiate or suffocate if you are exposed to too much for too long. Non-Emergency There are other warning signs that are less immediately serious, but you need to pay attention to them, regardless, as they could quickly turn serious: Corrosion Always inspect your pipes regularly, and if you see rust or other corrosion on them, be sure to call a qualified contractor right away. There may also be an issue if you notice flaking or bubbling of paint near your gas lines or a lot of dampness and residue around the fittings. A professional can seal joints and even replace a bad section of pipe if needed. Hissing If you hear hissing near a gas appliance or a meter, it likely means that gas is escaping. Even a little bit of a leak can increase your bills, of course, and indoors, it can create a very dangerous condition. Contact a professional contractor right away to take a look. If it's a single appliance, turn off the gas to that appliance. Bigger Bills If your habits haven't really changed, but the cost of your gas bill keeps going up, try turning off all your gas appliances and writing down the meter reading. Then, wait for an hour or two and check the meter again. If it has gone up, you have a leak. Low Pressure If the flame on your stove or in your furnace doesn't have the power it should have, then you could have a leak somewhere in the line leading to that appliance, or there could be a blockage. There also could be a faulty regulator in the appliance itself or corrosion in the piping. If several appliances seem to be affected, then the issue could be farther down the line and could be either your responsibility or something that your utility company needs to deal with. A contractor can investigate the situation and help you figure out what's going on. If you're noticing any issues with your gas line, schedule an appointment with us at Economy Plumbing Service LLC in Tucson or call us 24/7 at 520-885-3510. We also serve Vail, Rita Ranch, Oro Valley, and Green Valley.

home water repiping plumber in AZ

Signs Your Home Needs Repiping: When Tucson Homeowners Should Replace Old Pipes

Most homeowners do not think about their plumbing pipes until there is a major leak or a sudden drop in water pressure. However, aging pipes can create ongoing problems that repairs may only temporarily fix. If your Tucson home has older plumbing, whole house repiping may be the right solution to improve reliability and prevent future damage. Economy Plumbing Service, LLC helps homeowners identify when their plumbing system needs more than another repair. Knowing the warning signs can help you address problems before they become expensive emergencies. more What Is Whole House Repiping? Whole house repiping involves replacing old or damaged plumbing pipes throughout a home. Instead of repairing one failing section at a time, repiping replaces aging pipes with new plumbing materials designed to provide better water flow and long-term performance. Many older Tucson homes still have original plumbing systems that may be affected by corrosion, mineral buildup, and years of use. Signs Your Home May Need Repiping Frequent Pipe Leaks If you are regularly dealing with leaking pipes or repeated plumbing repairs, the problem may be the age and condition of your entire plumbing system. Multiple leaks in different areas of your home often indicate that the pipes are reaching the end of their lifespan. Low Water Pressure Low water pressure throughout your home can be a sign of restricted or deteriorating pipes. Mineral buildup from Arizona’s hard water can collect inside plumbing lines over time, reducing water flow and making faucets and fixtures less effective. Discolored Water Brown, rusty, or cloudy water may indicate corrosion inside older pipes. While occasional discoloration can happen for several reasons, ongoing issues should be inspected by a professional plumber. Noisy Pipes Banging, knocking, or rattling pipes can point to underlying plumbing problems. While some noises are minor, consistent sounds may indicate aging pipes or pressure issues that require attention. Older Plumbing System The age of your home is an important factor when considering repiping. Many older homes in Tucson have plumbing materials that can become more vulnerable to leaks, corrosion, and reduced performance over time. Why Tucson Homes Can Have Unique Plumbing Issues Arizona plumbing systems often deal with hard water, which can contribute to mineral buildup inside pipes. Over years, this buildup can restrict water flow and place additional strain on your plumbing system. For older Tucson homes, replacing outdated pipes can help improve water pressure, reduce repairs, and provide a more dependable plumbing system. Is Repiping Better Than Constant Repairs? If you are frequently repairing leaks or dealing with ongoing plumbing problems, replacing your pipes may be more cost-effective than continuing temporary fixes. A complete repipe can provide: Improved water pressure Fewer plumbing repairs Reduced risk of leaks More reliable water delivery Schedule a Repiping Inspection in Tucson, AZ If your home has frequent leaks, low water pressure, or aging pipes, Economy Plumbing Service, LLC can help determine whether repiping is the right option. Our Tucson plumbing team provides professional repiping services and whole house pipe replacement to help homeowners protect their homes and improve their plumbing systems. Contact Economy Plumbing Service, LLC today to schedule a plumbing inspection and find out if your Tucson home needs repiping.